Ernest Belmore III Injured in Alleged Drunk Driver Accident in Garland, TX

Basic Facts

Crash date: April 12, 2026

Crash location: President George Bush Turnpike near Mansion Drive in Garland, TX

People involved:

• Ernest Edmond Belmore III, 35
• Unidentified Chevrolet driver, 35
• Unidentified Audi driver

Do authorities suspect alcohol played a role in this crash? Yes

Did authorities recommend criminal charges? Yes

Do authorities suspect a product defect caused the crash? Unknown

Accident Report

Garland, TX — April 12, 2026, Ernest Belmore III was injured in an alleged drunk driver accident just after 6 p.m. on President George Bush Turnpike/State Highway 190.

A preliminary accident report indicates that a 2023 Chevrolet Blazer was heading west when it rear-ended a 2017 Ford F-150, causing the other vehicle to overturn, A 2018 Audi A-4 was damaged in the crash as well.

Ford driver Ernest Edmond Belmore III, 35, was seriously injured in the crash, according to the report.

The other two drivers were not hurt, the report states, but the Chevrolet driver was charged with intoxication assault after the crash, the report states.

Authorities have not released any additional information about the Dallas County crash at this time.

How Did This Accident Occur?

The investigation into this crash shouldn’t be over once authorities determine if it happened as described in the initial crash report. It warrants additional scrutiny if blood tests confirm the Chevrolet driver was intoxicated at the time of the crash because where he had been drinking matters.

It’s one thing if he had been drinking at home, but if he was served at a restaurant or bar while obviously intoxicated, that alcohol provider may share responsibility under Texas law for any injuries he caused after getting behind the wheel. Right now, there is no way to know if that is what happened in this instance, but the injured driver and his family will never know who might have played a role in this crash unless this is fully investigated.

Do you know anything that might help with this probe? Let us know in the comment section.