Denton County, TX — August 8, 2024, Abiyya Munir was injured due to a car accident at approximately 12:15 p.m. along Hebron Parkway.
According to authorities, 31-year-old Abiyya Munir and two children were traveling in a northbound Kia Sportage attempting a left turn from International Parkway to head westbound on Hebron Parkway when the accident took place.
Officials indicate that, for as yet unknown reasons, an eastbound BMW SUV that had been traveling on Hebron Parkway entered the intersection at an apparently unsafe time, failing to stop for the red light. A collision consequently occurred between the front-right of the BMW and the front-left quarter of the Sportage. The impact pushed the Sportage into a Honda Accord that had also been making a left turn in the lane next to it.
Munir reportedly sustained serious injuries over the course of the accident. A 64-year-old man who had been behind the wheel of the Honda suffered minor injuries, as well, reports state. Additional details pertaining to this incident are not available at this point in time.
Commentary by Attorney Michael Grossman
When a driver runs a red light and causes a crash that seriously injures someone—especially when children are involved—the need for answers becomes urgent. But beyond the surface explanation lies a more important question: was this just a mistake, or was there more to the story?
Did the authorities thoroughly investigate the crash?
Crashes at controlled intersections require more than just a summary of who had the green. Did investigators review the timing of the lights and confirm whether the BMW truly entered on red? Was camera footage pulled from the intersection or nearby businesses? Scene measurements and signal phase analysis can help determine how long the light had been red and whether the Sportage had already begun turning. Without that level of scrutiny, critical moments leading up to the crash may never be fully understood.
Has anyone looked into the possibility that a vehicle defect caused the crash?
If the BMW SUV failed to stop for a red light, it’s fair to ask whether that failure was entirely the driver’s. Brake system problems, delayed throttle response, or issues with advanced driver-assist systems like collision avoidance or lane monitoring might have prevented a safe stop. Vehicles today rely on a complex mix of mechanical and electronic systems—and any one of them failing could turn an ordinary stop into a high-speed impact. A thorough inspection is needed to rule those issues out.
Has all the electronic data relating to the crash been collected?
Both the BMW and the Sportage are likely equipped with systems that store pre-crash data. That includes speed, braking attempts, steering angle, and even whether driver-assist warnings activated. Reviewing this data can confirm how fast the BMW was going, whether it slowed at all, and whether the Sportage was already established in the turn. Video evidence—if available—can be even more decisive in showing the order of events. Without these tools, conclusions about fault or timing rest too heavily on assumption.
When serious injuries happen at intersections where drivers are expected to follow clear signals, the question isn’t just who entered first—it’s whether all the warning signs were working, whether anyone reacted in time, and whether anything inside the vehicles failed to do its job.
Key Takeaways
- Crashes in signal-controlled intersections need precise review of light cycles and vehicle timing.
- A failure to stop may point to mechanical or electronic issues that require inspection.
- Data from the vehicles and traffic cameras can help confirm what actions were—or weren’t—taken.
call us 
Email Us 
Text us